Red-lion ILS Manuel d'utilisateur télécharger pdf

DESCRIPTION

These devices, when installed across an inductive load, such as a contactor,

solenoid or relay, will suppress transient surges during a switching. This will

enhance relay life and provide increased reliability of operation.

There are two devices available, one for use in 115 volt circuits and one for

use in 230 volt circuits.

INDUCTIVE LOAD SUPPRESSOR

Fully slide PVC insulating tubing over Model ILS leads, as shown.

Caution: Ensure VAC is “OFF” before installing Model ILS.

ILS

ORDERING INFORMATION

ILS SPECIFICATIONS *

*NOTE: These devices will suppress most transient surges. However, if the device heats up or stops functioning after a short period of time a higher joules rated device may be required.

Bulletin No. ILS1/2-D

Drawing No. LP0151

Released 06/13

Tel +1 (717) 767-6511

Fax +1 (717) 764-0839

www.redlion.net

MODEL NO. DESCRIPTION PART NUMBER

ILS1 115 VAC Inductive Load Suppressor ILS11500

ILS2 230 VAC Inductive Load Suppressor ILS23000

RATED VOLTAGE

DEVICE MODEL

NUMBER

AC VOLTS DC VOLTS

SINGLE PULSE

TRANSIENT

ENERGY JOULES

POWER DISSIPATION

WATTS

CLAMPING VOLTAGE

VOLTS

RATED PEAK

SINGLE PULSE

TRANSIENT CURRENT (AMPS)

ILS1 130 175 6500 80 1.0 340 V @ 100 A

ILS2 275 370 6500 150 1.0 710 V @ 100 A

Do not dispose of unit in trash - Recycle

1 2

Résumé du contenu

Page 1 - INDUCTIVE LOAD SUPPRESSOR

1DESCRIPTIONThese devices, when installed across an inductive load, such as a contactor, solenoid or relay, will suppress transient surges during a sw

Page 2 - INSTRUMENT

Most electronic equipment designed for use in industrial environments has a high degree of noise immunity and protection against damage. But even the